EN
30
3. Bike assembly
This chapter aims at helping you remove your bike from the ROSE bike box and re-assemble it.
Front wheel, handlebar and seat post have been removed for shipping. In addition, you have to install the pedals and check
whether your bike is in a roadworthy condition.
DANGER
Improperly installed components can cause serious crashes!
Any improperly installed components could loosen during the ride!
• Always follow the installation instructions included in this manual.
• If in doubt, please consult the ROSE service team or a qualified bicycle mechanic.
In addition to this manual, you will find some videos on how to assemble your bike at rosebikes.com.
3.1 Required tools
Depending on bike model and equipment, you will need the following tools for assembly:
• 4 mm, 5 mm, 6 mm, 8 mm hex wrench
• Torque wrench with a 4 mm, 5 mm, 6 mm and 8 mm hex drive
• 15 mm open-ended spanner
To Next Page
Loading...