Safety
12 / 89
Intended use
4 Safety
4.1 Intended use
Improper use of the product can result in personal injury. Additionally, the
product or other material assets of value may be damaged.
Rosenbauer can warrant the safety, reliability and performance of its prod-
uct only if the product is used in accordance with the stipulations in this
manual.
Unauthorised changes, unauthorised conversions or improper operation
can detract from the intended use and result in personal injury or property
damage.
Firefighting products may be used only in a flawless technical condition by
qualified personnel for the following purposes:
• Implementation of technical assistance
• Rescue of people from emergencies
• Firefighting
Only manufacturer-authorised persons may perform modifications, conver-
sions and repairs. Unauthorised changes, unauthorised conversions or im-
proper use will nullify all manufacturer liability for resulting damages.
The power generator generates electrical energy for feeding into a mobile
distribution system as part of a network replacement operation. In order for
the generator to be used for the supply of stationary consumers (building
feed), the power generator and the system must have a corresponding
electrical installation.
The power generator must not be connected to other power distribution
(e.g. public power supply) and power generation systems (e.g. other power
generators) (grid-parallel operation). The power generator may only be
used outdoors within the specified limits for voltage, power and rated speed
(see type plate). In emergency situations, use on a vehicle or equipment ex-
tension or swivel/rotary compartment in the inserted or swivelled state is
also permitted if the equipment is supplied with fresh air through sufficiently
dimensioned air intake openings in the body and, in particular, the air flow
at the air intake and air exhaust openings is not impaired and heat accumu-
lation is avoided. The exhaust gases must be discharged into the open air.
4.2 Markings and warning signs
Safe use is only possible, if all necessary information for a safety operation
are observed. These informations are especially including safety- and
warning instructions.
In addition to the instructions in this operating manual read and observe all
the safety- and warning signs affixed to the product.
4.3 Other regulations
This product has been manufactured in accordance with the applicable reg-
ulations and the state of the art.
To Next Page
Loading...