Service and cleaning
76 / 89
Preserving and storing
Painting work or working with chemicals or aggressive substances:
NOTICE
Damage to electronic components
Due to high temperature in a paint box, electronics can be severely
damaged.
Expose electronics to max. 95 °C (203 °F) for a short period.
Dry time must not exceed 2 hours at 85 °C (185 °F).
► Protect the electronics, contacts and plug connector from paint spray
mist and the effect of aggressive substances.
Storing, packing and transporting
Electronics with Housing:
Precautions regarding anti-electrostatic problems are not necessary. To
protect them against soiling and climatic effects, a plastic foil must be used
when packaging. Sufficient filling material must be used to avoid mechani-
cal damage during shipment of unit.
Printed Cards/chips boards:
Components like printed cards must be properly packed (wrapped) into
anti-electrostatic foil. The anti-electrostatic foil is enough to protect them
from soiling to. Printed cards are extremely sensitive to mechanical dam-
age. Therefore boxes, sufficient in size, with ample filling material must be
used for shipment/transport. Shipment in "Jiffy-Bags" is not permissible.
The same recommendations apply when carrying these items in tool boxes
etc.
General Requirements:
Maximum permissible limits for storage and transporting are as follows:
Temperature: -40° C to +100° C (-40° F to +212° F)
Humidity: 20% up to 95%
No condensation permissible.
It is essential to store electronic components either packed in protection foil
(electronics with housing) or packed in anti-electrostatic foil (printed cards).
8.6 Preserving and storing
The power generator and the corresponding installation material must be
stored and transported in the packaging.
► Handle the carefully and cautiously.
If the power generator is not operated for a longer period of time (> 2
months) the following advice must be observed.
► Drain fuel injection system and fuel tank (deplete or pump away).
► Thoroughly clean the power generator with moist cloths (use no run-
ning water or solvent).
To Next Page
Loading...