Operation
48 / 89
Preparation for startup
Dismantle transport device
► The disassembly of the transport device takes place in reverse order
to the assembly.
The wheels are disassembled.
Transporting power generator
► Lift the power generator on the underfloor hydrant key.
► Raise the power generator so that it stands on its wheels.
The power generator can be moved by 1 person.
► Swivel the carrying handles of the power generator back in after trans-
porting.
Additional operating personnel are required to move on inclined passages
and slopes.
7.3 Preparation for startup
The sequence of the described processes is to be maintained without ex-
ception!
Before each start-up it should be checked that all operating materials (oil
etc.) are full.
► Carry out complete visual checks.
► Check all relevant indicators and instruments for function and condi-
tion.
► Fill the fuel tank.
For further information refer to Chapter "Refuel".
► Wear personal protection equipment.
For further information refer to Chapter "Service and cleaning".
7.4 Positioning the power generator
► Ensure the power generator is on a secure footing.
► Position the power generator well away from flammable materials.
Wood, leaves, hay, dry grass, etc. can be ignited by exhaust
fumes and hot surfaces.
► Observe maximum permissible inclination.
• Maximum inclination 15° in all axes.
• When external refuelling is used, the maximum inclination must
not exceed 5° in all axes.
The maximum inclination of the portable pump only applies when
the oil is filled to the maximum level.
► If it is operated on loose surfaces or if it is tilted during operation, the
power generator must be secured against slipping and falling over.
To Next Page
Loading...
Need help?
General