Service and cleaning
66 / 89
Service plan
8.1.3 Dry vehicle and equipment
Load only dried equipment into the vehicle, to conserve the service life of
the equipment and the vehicle.
► Let the equipment and device dry before loading.
► Open compartments of the vehicle in the vehicle garage.
8.2 Service plan
8.2.1 Maintenance according to the manufacturers operation manual
Observe the operating and maintenance manual of the engine manufactur-
er.
8.3 Torque tables
The bolting (under screw head and on thread) must not be oiled under any
circumstances and tighten invariable by using a torque wench.
Tightening torques acc. to DIN 13-1 are to be complied with.
In particular the connecting elements are to be checked.
To Next Page
Loading...