Technical description
42 / 89
Optional equipment
Assembly of the adapter may only be carried out by trained personnel. Take
note of general dangers that could occur during assembly.
► Mount tripod adapter and plain bearing to the retaining plate with oval
head screws.
► Seal in the oval head screws with Loctite 542.
► Mount retaining plate to the power generator with oval head screws.
The oval head screws with which the retaining plate is mounted
on the power generator form a conductive connection on the pow-
er generator and must therefore be earthed.
Observe the direction of the toothing on the earthing disks during
installation.
Retaining plate assembly
1 Retaining plate teeth direction
2 Retaining plate teeth direction
3 Rear wall plate teeth direction on power generator
► Insert the lighting head into the adapter support with the extensions
and cable into RLS light head connection.
The extensions can be individually locked by twisting, to prevent
accidental loosening or falling out of the lighting head.
To Next Page
Loading...