Ross Graphite - To Set the Media-Store Attribute; To Set the Aux Bus Attribute; Clear Memories; To Clear the Memory Registers

3.
Use the Key knob to select the keyer you want to
set the attribute for.
4.
Use the Value knob to select whether mask settings
for the selected key are recalled.
•
Memory — settings come from the memory
being recalled
•
NoRcl — key mask settings are not recalled
•
Recall — key mask settings are recalled
(default)
To Set the Media-Store Attribute
1.
Press MENU > RECALL (or ME 1 RECALL) >
NEXT.
2.
Use the Attrib knob to select Media.
3.
Use the Media knob to select the Media-Store
channel you want to set the attribute for.
4.
Use the Value knob to select whether Media-Store
image and settings for the selected channel are
recalled.
•
Memory — settings come from the memory
being recalled
•
NoRcl — Media-Store image and settings are
not recalled (default)
•
Recall — Media-Store image and settings are
recalled
To Set the Aux Bus Attribute
1.
Press MENU > RECALL (or ME 1 RECALL) >
NEXT.
2.
Use the Attrib knob to select Aux.
3.
Use the Aux knob to select the aux bus you want to
set the attribute for.
4.
Use the Value knob to select how the sources
selected on the aux bus are recalled.
•
Memory — settings come from the memory
being recalled
•
NoRcl — sources are not recalled on the aux
bus (default)
•
Recall — sources are recalled on the aux bus
To Set the Camera Shot Attribute
1.
Press MENU > RECALL (or ME 1 RECALL) >
NEXT.
2.
Use the Attrib knob to select CamRcl.
3.
Use the Value knob to select whether camera shots
are recalled.
•
Memory — settings come from the memory
being recalled
•
NoRcl — camera shots are not recalled
•
Recall — camera shots are recalled (default)
To Set the Roll GPO Attribute
1.
Press MENU > RECALL (or ME 1 RECALL) >
NEXT.
2.
Use the Attrib knob to select RllGPO.
3.
Use the Value knob to select whether GPI outputs
attached to sources are triggered when recalled.
•
Memory — settings come from the memory
being recalled
•
NoRoll — GPI outputs are not triggered
•
Roll — GPI outputs are trigged (default)
To Set the Roll VTR Attribute
1.
Press MENU > RECALL (or ME 1 RECALL) >
NEXT.
2.
Use the Attrib knob to select RllVTR.
3.
Use the Value knob to select whether a play
command is triggered when a source that is assigned
to a video server is recalled.
•
Memory — settings come from the memory
being recalled
•
NoRoll — play command is not triggered
•
Roll — play command is triggered (default)
Clear Memories
You can clear all the memory registers on the switcher
so that they are all empty. This deletes all the contents
of the memories.
You cannot clear individual memory registers.
To Clear the Memory Registers
1.
Press MENU > Reset > NEXT > NEXT.
2.
Press the Clear Mems knob to clear the memory
registers.
42 • Memory Functions — Graphite Operation Manual (v1.1)