ways. Use the following information to help you set up
Windows
®
audio.
•
The Recording Device must be set to Digital Audio
Interface.
•
The Default Playback Device should be set to Digital
Audio Interface to be able to send Windows
®
audio
to the audio mixer.
•
The Listen to this device option should be selected
on the Listen tab on the Digital Audio Interface
Properties.
•
The Speakers (High Definition Audio) option
should be selected on the Play back through this
device list.
Keep the following in mind when using Windows
®
audio
to work with the audio mixer:
•
If Listen to this device is not selected you will
have the Windows
®
audio in the Main output of the
mixer, but not on the monitoring headphone jack.
•
If Listen to this device is selected and Speakers
(High Definition Audio) is not selected on the Play
back through this device list there will be echo
in the Main output of the mixer and no audio on the
monitoring headphone jack.
•
If Listen to this device is not selected and
Speakers (High Definition Audio) is not selected
on the Play back through this device list the
Main output of the mixer will be normal, but there
will be no audio on the monitoring headphone jack.
•
If the Default Playback Device is set to Speakers
(High Definition Audio), and not Digital Audio
Interface, the audio will not be included in the Main
output of the mixer, but there will be audio on the
monitoring headphone jack, even if Listen to this
device is not selected.
Graphite Operation Manual (v1.1) — Audio Mixer • 45
To Next Page
Loading...