3 CHAPTER 3 - PACKING, TRANSPORT AND STORAGE
Only skilled personnel who are familiar with the lift and this manual shall be allowed to carry out
packing, lifting, handling, transport and unpacking operations.
The lift is supplied disassembled into sub-assemblies depending on the model ordered.
Model N:
N° 2 base units, each one with a flat runway and 2 hydraulic cylinders
N° 1 control unit equipped with hydraulic unit;
N° 1 box containing hydraulic lines, stickers and technical documentation;
N° 2 drive-on ramps with 2 stop wheels and 4 protective devices to connect runways for
on-floor installation or 4 drive-on ramps for in-ground installation.
Model AT:
N° 2 base units, each one with a runway equipped with recessing for the graduated plates
and slip plates for wheel alignment, and 2 hydraulic cylinders;
N° 1 control unit equipped with hydraulic unit
N° 1 box containing hydraulic lines, stickers and technical documentation;
N° 2 drive-on ramps with 2 stop wheels and 4 protective devices to connect runways for
on-floor installation or 4 drive-on ramps for in-ground installation.
Model LT:
N° 2 base units, each one with a flat runway equipped with lift-table for further lifting of
the vehicle, and 4 hydraulic cylinders;
N° 1 control unit equipped with hydraulic unit
N° 1 box containing hydraulic lines, stickers and technical documentation;
N° 2 drive-on ramps with 2 stop wheels and 4 protective devices to connect runways for
on-floor installation or 4 drive-on ramps for in-ground installation.
Model LTAT:
N° 2 base units, each one with a flat runway equipped with recessing for the graduated
plates and slip plates for wheel alignment, and lift-table for further lifting of the
vehicle, and 4 hydraulic cylinders;
N° 1 control unit equipped with hydraulic unit
N° 1 box containing hydraulic lines, stickers and technical documentation;
N° 2 drive-on ramps with 2 stop wheels and 4 protective devices to connect runways for
on-floor installation or 4 drive-on ramps for in-ground installation.
If requested, optional accessories are available to satisfy each customer’s requirements (Ref.
accessories manual and price lists).
The lift is packed in a single box on a wooden bed, wrapped up in non-scratch waterproof material
and sealed with 2 straps.
The average weight of the package changes between 2000 - 2600 Kg.
To Next Page
Loading...
Need help?
General
