Rotary M50 - Set up and Adjustments; Mechanical Checks; Electrical Checks; Hydraulic System Check

 Press the DOWN button (8) until the platforms reach the security height (400 mm);
 i In case of platform difference in height, the photocell is operated preventing lift from
lowering up to the safety height: in this case press simultaneously the override button (15)
and the DOWN button (8);
 press final lowering button (5).
FOR MODELS “LT” AND “LTAT”:
 Turn the selector (11) in auxiliary lift position;
 Push the UP (7) to raise the lift-tables;
After stopping the lift-table platform P2, proceed with the bleeding as described below:
 Push simultaneously the override (15) and UP button (7) until the lift-tables reaches the
maximum height ;
 Push, for a few seconds, both buttons until the P2 cylinder hole return hose is bled;
 Push the DOWN (8) button for lowering the platforms to the safety height (130 mm);
 press final lowering button (5)
NOTE: PLATFORMS LOWERS WITHOUT MOTOR SUPPORT BECAUSE IT STARTS AFTER DEACTIVATING THE
UP LIMIT SWITCH ON P2 LIFT-TABLE
7.9 CHECKS AND INSPECTIONS
7.9.1 MECHANICAL CHECKS
 Platform leveling and alignment;
 Fix the lift to the ground with 8 anchor bolts (min. recommended size ø = 16 mm tighter ),
bolts, connectors and connections.
 Clean all parts of the equipment
7.9.2 ELECTRICAL CHECKS
 connections as per diagrams
 lift grounding (earthling)
 operation of the devices and limit switches
7.9.3 HYDRAULIC SYSTEM CHECK
 proper oil level in the tank
 no leakage and blow-by
 cylinder operation
7.10 SET UP AND ADJUSTMENTS
7.10.1 LOADLESS CHECK
Carry out two or three complete cycles of lowering and lifting and check:
 the lift for reaching its maximum height
 the max height limit switch for proper operation
 the lowering limit switch for proper operation