INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 29 of 57
13.5.1 Balancing mode
The machine has the ability to perform the wheel bal-
ancing (weights fitting) in 3 different ways:
- using the distance-diameter caliper arm with weights
fitting grippers;
- using the laser at “6 o'clock”;
- weights fitting at “6 o'clock” (without the use of lasers).
- weights fitting at “12 o'clock” (with the use of lasers)
(optional).
• Weights fitting with distance-diameter caliper
arm.
1. Place the adhesive weight on the arm grippers.
Fit the adhesive weight
in the pliers of the gauge rod
2. Pull out the gauge until the arrows (Fig. 34 ref._6)
both turn green.
3. Rotate the gauge arm until the weight touches the
rim.
Fit weight on the position
where pliers touches the wheel
4. Bring the distance-diameter caliper arm into rest-
ing position.
5. Press the
button to change the weight fit-
ting side.
6. Proceed in the same way as described in points
1-2-3.
BEFORE REMOVING THE DIAME-
TER-DISTANCE CALIPER, PRESS
THE BRAKE PEDAL AND HOLD IT
DOWN UNTIL THE WEIGHT HAS
NOT BEEN APPLIED, ENSURING IN
THIS WAY THAT, DURING THESE
PHASES, THE WHEEL CAN NOT
ROTATE.
• Weights fitting with laser (at "6 hours").
TO USE THIS MODE, IT IS NEC-
ESSARY THAT FUNCTION
AND FUNCTION
ARE ENA-
BLED BY PRESSING RELEVANT
BUTTONS FROM THE MENU “OP-
TIONS” (PAR. 14.1).
TO USE THIS WEIGHT APPLICA-
TION MODE THE OPERATOR
MUST REMEMBER THE PRECISE
POINT WHERE THE MEASURE-
MENT WAS TAKEN WITH THE
DISTANCE-DIAMETER CALIPER
ARM.
At the end of the spin, on the rim at "6 hours" is
displayed a laser beam (blade) indicating the axis
on which to apply the weight. The positioning of the
weight (s) in depth shall be at the discretion of the
operator, depending on where remembers taking
the measure.
BE SURE TO APPLY THE WEIGHT
(INTERNAL OR EXTERNAL) AS
INDICATED BY THE 2 GREEN AR-
ROWS (Fig. 34 ref. 2 or 3) ON THE
CORRESPONDING
MONITOR SCREEN.
• Weights fitting at “6 o'clock” (without the use of
lasers).
TO USE THIS MODE, IT IS NECES-
SARY THAT THE RELEVANT FUNC-
TION IS ENABLED ON THE
MENU "OPTIONS" DESCRIBED IN
PAR. 14.1.
1297-M008-8
To Next Page
Loading...