INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 31 of 57
After entering all the required measures, you can spin
the wheel by pressing the button and closing
the protective guard.
NOTE: if the distance-diameter caliper is disabled,
the displayed page for detected unbalance is
as follows:
Fig. 36
1 2
In this screen page,in addition to the information of
the detected unbalance, there are measurements in
mm where you must remove the gauge arm (Fig. 36
ref._1-2) to apply the weights inside the rim.
13.7 Standard balancing programs
13.7.1 Static
The STATIC program permits balancing wheels by fit-
ting adhesive weights on the outer and inner sides of
the rim. Enter the measurements (see Par. 13.2.1 or
13.6.1) and proceed as described in Par. 13.5.
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The procedure has now been completed.
13.7.2 Static-1
STATIC 1 function is a procedure that offsets wheel
vibrations using a single weight with clip on a single
plane positioned exactly at “12 o'clock”.
Enter the measurements (see Par. 13.2.1 or 13.6.1) and
proceed as described in Par. 13.5 "Dynamic balancing"
(only for wheel inner side).
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The procedure has now been completed.
13.7.3 Static-2
STATIC 2 function is a procedure that offsets wheel
vibrations using a single adhesive weight on a single
plane positioned exactly at “12 o'clock”.
Enter the measurements (see Par. 13.2.1 or 13.6.1) and
proceed as described in Par. 13.5 "Dynamic balancing"
(only for wheel inner side).
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The procedure has now been completed.
1297-M008-8
To Next Page
Loading...