GB
Page 36 of 57
INSTRUCTION, USE AND
MAINTENANCE MANUAL
13.8.2 Weights hidden behind spokes mode
Adhesive correction weight positioning may not look
attractive on some types of rims. In this case, "weights
hidden behind spokes" mode can be used: it splits any
correction weight on the outer side into two parts to
be hidden behind rim spokes. It can be used in both
ALU-S or STATIC modes.
Display the ALU-S or STATIC, unbalance measure-
ments, by performing a standard wheel spin.
Once detected the unbalance values, verify that the
machine displays the ability to use the "spokes" options
(Fig. 34 ref. 4b).
Press button
to shift to the next screen page.
Press button to enter the relevant function.
On the monitor the next screen page will be displayed:
Bring any spoke upwards at "12 o'clock" position and
press the button
to confirm and continue.
A
Lead to “12 hours” the 2nd spoke. The machine will
automatically calculate the total number of spokes. If
the value shown on the screen (A) is correct, press the
button
.
The machine automatically calculates weight position
in two positions hidden behind the spokes. The moni-
tor shows the amount of weight to be applied behind
the FIRST spoke and the rim will reach the position
to apply the FIRST weight.
Extract the gauge rod, and fit the FIRST weight in
the position shown by the machine, as explained in
Par. 13.5.1. Press the button
to confirm that
they have applied the FIRST weight and to automati-
cally position the wheel for the fitting of the 2nd weight.
The monitor shows the amount of weight to be applied
behind the SECOND spoke.
Pull out the gauge rod and fit the SECOND weight in
the position shown by the machine, as done for the
first weight.
Press the button
to confirm that you have ap-
plied the SECOND weight and get back to the initial
situation of unbalance, before performing the "weights
hidden behind the spokes" procedure
Perform another test spin. The “weights hidden behind
spokes” procedure is completed.
1297-M008-8
To Next Page
Loading...