GB
Page 32 of 57
INSTRUCTION, USE AND
MAINTENANCE MANUAL
13.7.4 Dynamic
The DYNAMIC program allows the wheels balancing
by fitting two clip adhesive weights: one on the outside
and one on the inside rim. Enter the measurements
(see Par. 13.2.1 or 13.6.1) and proceed as described
in Par. 13.5.
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The procedure has now been completed.
13.7.5 ALU-S
ALU-S program permits balancing wheels by two fit-
ting adhesive weights on the outer and inner sides of
the rim. Enter the measurements (see Par. 13.2.1 or
13.6.1) and proceed as described in Par. 13.5.
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The procedure has now been completed.
13.7.6 ALU-S1
ALU-S1 function permits balancing wheels with light
alloy rims by fitting adhesive weights on the outer
side and weight with clip on inner side of wheel (at
“12 o'clock”).
Enter the measurements (see Par. 13.2.1 or 13.6.1)
and proceed as described in Par. 13.5 (the inner weight
is with clip).
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The procedure has now been completed.
13.7.7 ALU-S2
ALU-S2 function permits balancing wheels with light
alloy rims by fitting two adhesive weights: one on the
outer and one on inner sides of the rim (the inner
weight is at 12 o’ clock).
Enter the measurements (see Par. 13.2.1 or 13.6.1)
and proceed as described in Par. 13.5.
At the end of the procedure, the wheel balancing condi-
tions can be checked by performing a trial spin.
The procedure has now been completed.
1297-M008-8
To Next Page
Loading...