INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 45 of 57
KEY
A – Program used in the last carried out spin
B – Acquired measurements for the last carried
out spin
A
B
Press any of the available numbers on the buttons at
the bottom of the page to select the corresponding user.
The system stores the data relating to the last per-
formed spin according to the different operators. You
can recall the desired user each time the program dis-
plays the specific button (Fig. 43 ref. 2 and Fig. 44
ref. 1). The measurements stored for each user are
lost when the machine is switched off.
User management is valid for any wheel balancer
function.
TO ENABLE OR DISABLE "USER
MANAGEMENT" FUNCTION, SEE
PARAGRAPH 14.1. IF THE FUNC-
TION IS DEACTIVATED, THE BUT-
TON
IS DISPLAYED.
14.2 Machine calibrations
Press the button (Fig. 41 ref. 2) to display the
following screen page on monitor:
1 2 3
KEY
1 – Mandrel “0” (zero) calibration
2 – Weight measurement sensors calibration
3 – Gauges calibration
Fig. 45
1297-M008-8
To Next Page
Loading...