Rotem P-COMM-V1 - Communicator User Functions; Voice Functions

Communicator | 3.05 16
5 COMMUNICATOR TO USER FUNCTIONS
The following sections detail how to use the:
• Voice, page 16
• Pager, page 20
• Text, page 21
• Common Functions, page 25
5.1 Voice Functions
The following sections detail Communicator’s basic and advanced Voice functions.
• Basic Voice Functions, page 16
• Advanced Voice Functions, page 17
• Responding to an Audio Alarm Message, page 19
5.1.1 Basic Voice Functions
This section details the basic Voice functions.
• Setting the Voice Parameters, page 16
• Testing Voice Quality, page 16
• Testing the Voice Call Service, page 17
• Testing the Cellular Signal Strength, page 17
• Receiving a Status Report, page 17
5.1.1.1 Setting the Voice Parameters
1. Select SYSTEM > Advanced Setup > Voice.
2. Define the speech VOLUME and SPEAKER volume and it’s SPEED (if using a TTS voice
card).
3. Scroll down to TEST and press ENTER to hear the selected settings.
5.1.1.2 Testing Voice Quality
1. Select SYSTEM > Test > Voice.
2. Define speech VOLUME and SPEED.
3. To test, press ENTER.
NOTE: Voice Setting and Test Voice perform the same functions.
VOICE SETTING

VOLUME


SPEED


SPEAKER  
VOICE SETTING

VOLUME


SPEED

