Communicator | 3.05 58
12.5 Voice Card
Voice does not function
Figure 19: Voice Card Location
1. Refer to Testing Voice, page 16 and perform a voice test.
2. Change the parameters as required (refer to Testing Voice Quality, page 16).
NOTE: Do not forget to confirm by moving the cursor to the āTESTā parameter and pressing 'ENTER'.
3. Verify speaker cable is connected.
4. Turn volume trimmer on voice card until required volume is reached (Figure 20) (Refer to
Figure 10, page 46 / Figure 11, page 47 to see the voice card location).
5. If none of the above helps, contact your dealer.
Figure 20: Volume Trimmer
To Next Page
Loading...
