23 Communicator | 3.05
5.3.2 Advanced Text Functions
The following sections detail the advanced Text functions.
• Defining Who Can Text Communicator
• Configuring an SMS Ringtone
5.3.2.1 Defining Who Can Text Communicator
1. Go to SYSTEM > Advanced Setup > GSM.
This menu defines which cell phones can send messages to the Communicator via text.
2. In the Text From field, choose:
o Addr. Book (only those addresses which are text enabled) or
o Any (enables sending text via any cell phone).
NOTE: Acknowledgement messages are only sent when Addr. Book is selected.
5.3.2.2 Configuring an SMS Ringtone
If desired, a ringtone can play when an SMS message from Communicator arrives, thereby alerting you
of an upcoming message.
1. Go to SYSTEM > Advanced Setup > GSM.
2. In the Text Precall field, select Yes.
3. In the Precall time, enter the time (in seconds). This parameter ensures that there is sufficient
time for the phone to ring before the SMS tone plays.
5.3.3 Text Message Responses
This section details how to respond to a text message sent from Communicator to a mobile phone. The
response can reset a siren, an alarm, or acknowledge the messages.
Event Codes, page 40 lists the events corresponding to the codes sent in a text message.
• Resetting the Siren, page 24
• Resetting the Alarm, page 24
• Acknowledging a Message, page 24
TEXT FROM Addr. Book
TEXT PRECALL Yes/No
PRECALL TIME 5
Auto Answer 2
Operator STD
To Next Page
Loading...