Rotem P-COMM-V1 - Alarm Message Configuration; Message Delay and Repeat Parameters

41 Communicator | 3.05
10.3.2 Disabling Alarms
• Go to ALARM > Disabled Alarms
View disabled alarms and re-enable these alarms.
NOTE: : Alarms are disabled until 12:00 PM the following day.
• Scroll right to view message.
• Press +/- to re-enable the alarm and then press ENTER.
NOTE: Alarms that are re-enabled are cleared from the list.
10.3.3 Defining the Message Delay
• Go to ALARM > Options.
This menu defines the waiting times between an alarm event and its reporting.
• CALL-OUT (seconds): Define the waiting time before the communicator begins the reporting
sequence.
• BETWEEN USERS (seconds): Define the waiting time before contacting the next user within
the address book.
10.3.4 Defining the Message Repeat Parameter
• Go to ALARM > Options.
By default, when an alarm is sent, it must be acknowledged by one of the contacts. If there is no
acknowledgment, Communicator resends the alarm (refer to Acknowledging a Message, page 24). This
menu defines the waiting time before Communicator reinitiates the reporting (VOICE, PAGER, TEXT).
NOTE: Enter 0 to disable this option.
DISABLE ALARMS DISABLE ALARMS
HOUSE DISABLE CODE MESSAGE
23 YES 185

25 YES 155

TEXT
==MESSAGE REPEAT==
Voice 20
Pager 35
Text 35
===INTERNAL ALARM===
Delay(s) 60
Reminder (m) 60
Power Resto.Msg NO
OPTIONS
==MESSAGE DELAY===
Call Out (s) 60
Between Users (s) 60