Rotem P-COMM-V1 - Communicator Functions

37 Communicator | 3.05
9 COMMUNICATOR FUNCTIONS
The following sections detail functions which relate to the Communicator hardware and software.
• Saving and Restoring System Settings, page 37 • Viewing Relay Settings, page 38
• Test Functions, page 37
9.1 Saving and Restoring System Settings
• Go to SYSTEM > Save/Res Setting > Restore.
o RESTORE: Use this feature to restore all settings that were previously saved (restore
point is the date of the last save performed).
• Go to SYSTEM > Save/Res Setting > Save.
o SAVE: Use this feature to save all settings (once a SAVE is performed, this is the new
RESTORE point).
9.2 Test Functions
The following section details how to test Communicator functions.
• Testing the Backup Battery, page 37
• Viewing Device Status, page 38
• Viewing the Software and Hardware Version, page 38
9.2.1 Testing the Backup Battery
This section details the Backup Battery test.
• Select SYSTEM > Test > Battery.
To test the battery:
1. Unplug the unit.
2. View the battery test.
CAUTION In addtion to this test, refer to Testing the Alarm Backup Batteries, page 43.
MEMORY RESTORE POINT
21-FEB-10
CONTINUE?
NO

YES
CREATE A NEW MEMORY
RESTORE POINT
NO

YES
BATTERY TEST
-

+ 100%
Charger active