Communicator | 3.05 46
11 INSTALLATION
The following sections detail how to install the Communicator.
CAUTION Rotem recommends that only an authorized technician install and configure the
Communicator unit.
• Hardware Installation, page 46
• Completing the Installation, page 50
11.1 Hardware Installation
The following sections detail how to perform the Communicator’s physical setup.
• Preliminary Steps, page 46
• Connecting the Unit to External Components, page 48
• Additional Details, page 49
• USB Driver Installation, page 49
11.1.1 Preliminary Steps
1. Open the Communicator and verify that all required components are physically installed.
Figure 10 and Figure 11 illustrate sample Communicators and their components.
Figure 10: External Connection Box Connector and Internal Components (Sample) Board
Version 2.3
To Next Page
Loading...
