21 Communicator | 3.05
5.2.2 Advanced Pager Functions
The following section details the advanced Pager functions.
5.2.2.1 Configuring the Dial Delay
• Go to SYSTEM > Advanced Setup > Line Modem.
When dialing a pager service, some services require additional tone menu browsing (interactive voice
response). Use this feature to set a delay between the phone number and the tone browsing. Each
“,”represents the number of seconds in delay between the phone number and the next browsing
number. Refer to Pager Test, page 20 for more information.
5.3 Text Functions
The following sections detail the Communicator basic and advanced Text functions.
• Basic Text Functions, page 21
• Advanced Text Functions, page 23
• Text Message Responses, page 23
5.3.1 Basic Text Functions
The following sections detail the basic Text functions.
• Testing the Text Function, page 21
• Testing the SMS Ringtone, page 21
• Status Report, page 22
5.3.1.1 Testing the Text Function
This menu enables testing the text function.
1. Go to SYSTEM > TEST > GSM/ > SEND TEXT MSG.
2. Enter in the required mobile phone number to receive the “Test Text” and press ENTER.
3. Confirm that the mobile phone received the following text message:
“Your Communicator is ready to send alerts via text messages.”
5.3.1.2 Testing the SMS Ringtone
This menu tests the SMS ringtone service.
1. Go to SYSTEM > Test > Dial Out.
2. Enter the required phone number to receive the “Test Call”.
3. Press ENTER.
Destination Number:
Charger active
To Next Page
Loading...
