Rotem P-COMM-V1 - 10 Alarms; Introduction to Alarms and Responses

39 Communicator | 3.05
10 ALARMS
This section details how to:
• Configure advanced alarm settings.
• View the history of alarms and events
Basic Alarm functions are defined in the Initial Configuration, page 12.
• Introduction to Alarms and Responses, page 39
• Event Codes, page 40
• Advanced Alarm Settings, page 40
• Alarm and Events History, page 42
10.1 Introduction to Alarms and Responses
Figure 7 illustrates the alarm sequence. The flow ends when an alarm is acknowledged or is no longer
active.
Figure 7: Alarm Flow Chart
Responding to alarms can be done over:
• Land line: Via verbal and interactive messaging
• Cellular: Via text messaging
NOTE: Communicator does not support verbal and interactive messaging via cell phones.
Alarm
Generated In
House
Call Out Delay
Send an SMS
Message to
Contact 1
(if enabled)
Send a Phone
Message to
Contact 1
(if enabled)
Delay Between
Contacts
Send an SMS
Message to Last
Contact
(if enabled)
Send a Phone
Message to Last
Contact (if
enabled)
Reminder
Delay
Response
from User
Yes
End
No