Rotem P-COMM-V1 - Page 24

Communicator | 3.05 24
5.3.3.1 Resetting the Siren
NOTE: After typing the text message, press the 'Send' button to send it to the Communicator.
In the procedures below, the highlighted text shows the SMS text to be sent.
• Resetting the Siren of One House
!RX > 'Send SMS' to the Communicator cell phone number.
! = Start of message
R = Reset
X = Represents house number (can be any positive number from 1-64)
• Resetting the Siren of Several Houses
!RX#X#X > 'Send SMS' to the Communicator cell phone number
! = Start of message
R = Reset
X = Represents house number (can be any positive number from 1-64)
# = Sign separates between every house number
• Resetting the Siren for All Houses
!RALL > 'Send' to the Communicator cell phone number
! = Start of message
R = Reset
ALL = Can be typed both in capital letters or small letters.
5.3.3.2 Resetting the Alarm
To reset all the alarms, send the following text message:
!C > 'Send' to the Communicator cell phone number
! = Start of message
C = Communicator
5.3.3.3 Acknowledging a Message
If Message Repeat is enabled (refer to page 41), Communicator continues to send alarms until an
acknowledgement is sent.
• Requesting a Response for Every Sent Text Message
!AON > 'Send' to the Communicator cell phone number
! = Start of message
A = Acknowledgement
• Canceling a Response for Every Sent Text Message
!AOFF > 'Send' to the Communicator cell phone number
! = Start of message
A = Acknowledgement.