53 Communicator | 3.05
11.2.3.1 Local Network
1. Under Network Setup, select Local Network.
2. Select the required baud rate.
NOTE: The selected baud rate must be the same as the rate selected in the Communicator.
3. Select the communication port.
NOTE: If the connection is via the USB port, select Communicator.
4. Select the number of controllers and the controller type.
5. Press Start Scan.
RotemNet scans the system and lists the controllers.
11.2.3.2 Remote Network
1. In RotemNet, select Internet and click OK.
2. In the Internet Communication window set the:
a) Farms account name
b) Account Name
c) Chip serial number
NOTE: This information must be the same as the data entered in Communicator.
3. If you are configuring multiple farms:
a) Enter a name for each farm.
b) Enter an Ethernet chip number for each farm.
c) Configure the controller setup for each farm.
4. To connect to a farm, click Connect.
NOTE: Refer to Initial Configuration, page 12 for instructions on the initial configuration.
To Next Page
Loading...
