14
FA ROTEX Solaris RPS4 - 06/2015
4 x Installation
5. Suspend the controller from above in the fixing bracket.
– Make sure that the cable loops (as shown in fig. 4-27 and
fig. 4-28) point downwards.
6. Cabling of the solar operating pump P
S
:
– Connect the pump cable to the solar operating pump P
S
.
7. Lay the cable for the control system along the return line and
fix using cable ties.
4.2.5 Fit the covering hood
1. Slide the covering hood in position and align. Slide the
covering hood under the controller housing so that a constant
gap is produced round the controller.
2. Screw the covering hood to the controller housing on both
sides using countersunk head screws.
3. Fix the covering hood to the storage tank connection bracket
that is located underneath. Carefully screw the self-tapping
fixing screw (pre-installed in the covering hood) over the
depression in the lower section of the housing front and then
insert the covering cap.
Fig. 4-28 Work step 5
Fig. 4-29 Work step 6
Fig. 4-30 Work step 7
Fig. 4-31 Work step 1
Fig. 4-32 Work step 2
Fig. 4-33 Work step 3
To Next Page
Loading...
Need help?
General
