Interrupter Timer activated when opening if below xx% (Parameter 107)
This parameter sets the position that the interrupter timer start to be
active when the actuator is travelling in the open direction.
Interrupter Timer activated when closing if above xx% (Parameter 108)
This parameter sets the position that the interrupter timer start to be
active when the actuator is travelling in the close direction.
7.2.28 Language used (Parameter 109)
This parameter indicates if the language used in the local actuator display is the standard English
language or an alternative one.
7.2.28 IDs and notes (Parameters 111 - 120)
The ‘ID’ parameters contain information about the serial numbers of the Printed circuits boards inside
the actuator. The Manufacturing notes section contains details of the manufacture of the actuator i.e.
wiring diagram.
The final section ‘General notes’ is available to be written to for any notes required.
To Next Page
Loading...
