i. STRING: 0-82 characters
ii. INT: 0-200 characters
iii. SINT: Not Used
6) Delimiters: Configure the characters to add to the message.
a. Start Delimiter Count: Use this feature to add a common starting delimiter(s) to
messages being sent to the ASCII device.
i. Use this feature only if your ASCII device requires such delimiters.
ii. All ASCII messages will receive the starting delimiters selected.
b. End Delimiter Count: Use this feature to add a common end delimiter(s) to messages
being sent to the ASCII device.
i. Use this feature only if your ASCII device requires such delimiters.
ii. All ASCII messages will receive the end delimiters selected.
7) Data Conversion:
a. None (Default): Does no additional conversion on the data before sending it from the
gateway to the ASCII device.
b. Prepend NULL: Adds a NULL character to the beginning of each message that is to be
sent from the gateway to the ASCII device.
c. Postpend NULL: Adds a NULL character to the end of each message that is to be sent
from the gateway to the ASCII device.
Real Time Automation, Inc. 19 1-800-249-1612
To Next Page
Loading...
