RTA 490NBX - Page 31

0x10
Device state conflict
The device’s current mode/state prohibits the execution
of the requested service
0x11
Reply data too large
The data to be transmitted in the response buffer is
larger than the allocated response buffer
0x12
Fragmentation of a primitive value
The service specified an operation that is going to
fragment a primitive data value
0x13
Not enough data
The service did not supply enough data to perform the
specified operation
0x14
Attribute not supported
The attribute specified in the request is not supported
0x15
Too much data
The service supplied more data than was expected
0x16
Object does not exist
The object specified does not exist in the device
0x17
Server fragmentation sequence
The fragmentation sequence for this service is not
currently active for this data
0x18
No stored attribute data
The attribute data of this object was not saved prior to
the requested service
0x19
Store operation failure
The attribute data of this object was not saved due to a
fai
lure during the attempt
0x1A
Routing failure, request packet
too large
The service request packet was too large for
transmission on a network in the path to the destination.
The routing device was forced to abort the service
0x1B
Routing failure, response packet
too large
The service response packet was too large for
transmission on a network in the path from the
destination. The routing device was forced to abort the
service
0x1C
Missing attribute list entry data
The service did not supply an attribute in a list of
attributes that was needed by the service to perform the
requested behavior
0x1D
Invalid attribute value list
The service is returning the list of attributes supplied
with status information for those attributes that were
invalid
Real Time Automation, Inc. 31 1-800-249-1612