Ruby Tech GS-2224L User Manual

153
Per Trunking Group supports a maximum of 12 ready member-ports. Please
note that some decisions will automatically be made by the system while you are
configuring your trunking ports. Some configuration examples are listed below:
a) 12 ports have already used Static Trunk Group ID 1, the 13th port
willing to use the same Static Trunk Group ID will be automatically set
to use the “None” trunking method and its Group ID will turn to 0. This
means the port won’t aggregate with other ports.
b) 14 ports all use LACP Trunk Group ID 1 at most 12 ports can
aggregate together and transit into the ready state.
c) A port using the “None“ trunking method or Group ID 0 will be
automatically set to use the “None” trunking method with Group ID 0.
3-11-1.Port
Function name:
Trunk Port Setting/Status
Function description:
Port setting/status is used to configure the trunk property of each and every
port in the switch system.
Parameter description:
Port:
Port Number: 1-24
Method:
This determines the method a port uses to aggregate with other ports.
None:
A port does not want to aggregate with any other port should
choose this default setting.
LACP:
A port use LACP as its trunk method to get aggregated with other
ports also using LACP.
Static:
A port use Static Trunk as its trunk method to get aggregated with
other ports also using Static Trunk.
Group:
Ports choosing the same trunking method other than “None” must be

Ruby Tech GS-2224L Specifications

General

Brand	Ruby Tech
Model	GS-2224L
Category	Switch
Language	English

Summary

1. Introduction

1-3. Features

Details the hardware and management features of the GS-2224L switch.

2. Installation

2-1-4. Configuring the Management Agent of GS-2224L

Explains how to configure the switch's management interface via RS-232 or Ethernet.

2-1-5. IP Address Assignment

Explains IP address structure, classes, subnet masks, and private IP address blocks.

3. Operation of Web-based Management

3-1-4. IP Configuration

Guides on configuring the switch's IP address, subnet mask, default gateway, and DNS.

3-3. VLAN

Explains VLAN concepts and configuration, supporting Tag-based and Port-based VLANs.

3-8. ACL

Explains Access Control Lists (ACLs) for packet filtering based on various parameters.

3-10. 802.1X Configuration

Explains 802.1X port-based network access control for user authentication.

3-12. STP Configuration

Details Spanning Tree Protocol (STP) configuration for avoiding network loops.

3-20. Diagnostics

Covers device self-diagnostics, including diagnostics, loopback, and ping tests.

4. Operation of CLI Management

4-1-1. Login

Details the process of logging into the switch via the command-line interface (CLI).

4-2. Commands of CLI

Lists and categorizes available CLI commands, including global and local commands.

5. Maintenance

5-1. Resolving No Link Condition

Lists possible causes for a "no link" LED status on switch ports.

Appendix A Technical Specifications

Appendix B Null Modem Cable Specifications