KT332N Cutting &engraving control system user manual V1.1
Figure 8.5-2
User can press the up and down keys to select the layer number, and the "select block" will also
move. Select the layer number to be modified and press [ENT] ,the layer setting interface will pop
up, as shown in the figure below:
Figure 8.5-3
Refer to Section 8.10 for parameter setting operation. Press [Esc] to exit the interface and return
to the main interface.
8.6 Menu function
Press [Menu] in the main interface, the pop-up menu interface is as follows:
To Next Page
Loading...
