KT332N Cutting &engraving control system user manual V1.1
8.6.1.3 Blow Setting
In the parameter setting interface, press [Blow Setting], and the blowing setting interface pops up
as follows:
8.6.1-3
Refer to Section 8.10 for parameter setting operation. Press the [Esc] key. The interface exit and
returns to the previous interface.
8.6.1.4 Speed setting
Press [Speed Setting] in the parameter setting interface, and the speed parameter setting
interface pops up as follows:
图 8.6.1-4
Refer to Section 8.10 for parameter setting operation. Press the [Esc] key. The interface exit and
returns to the previous interface.
8.6.1.5 Machine configuration
To Next Page
Loading...
