KT332N Cutting &engraving control system user manual V1.1
Receiving, Unpacking, Inspection
The product has a plastic or metal casing to protect the exterior electrical component
from damage. The product is wrapped in a foam bag and packed in an antistatic bag.
If the package has any external damage, please check the goods and notify the
carrier of the damage situation in writing.
Important:
After receiving the products, please check whether the outer
packaging is in good condition, whether the product is complete
after unpacking, and whether the parts are in good condition. If you
find damage, please contact with us immediately.
Keep the packaging materials and wiring accessories when unpacking. Please be
careful when disassembling the package. After unpacking the goods, please check if
the parts are complete. If you find that the parts are missing or the parts are
damaged, please contact with us immediately. If you notice any obvious damage to
the device, do not install the device or commission the device.
KT332N cutting system delivery list is shown in the following: （ As the product is
constantly updated, the accessories that may be received are difference）
USB cable（2.0 double magnetic ring -3M）
black
Connecting the machine
case to the PC (USB
communication)
USB Adapter cable AM/AF(with single
magnetic ring-1M)
Connecting the machine
case to the controller U
disk interface
USB Adapter cable（with single magnetic
ring -1M）Black
Connecting the machine
case and the controller
USB communication
interface
6445- Five-core cable 1.5M
Standard wiring length is
1.5M
To Next Page
Loading...
