Web-based Configuration Guide System Settings
98
Click the arrow under Expand to view alarm details.
Click Delete to delete the corresponding alarm messages. You are advised to retain all alerts for review.
Click Unfollow and then click OK. The device will no longer report the corresponding alerts. After clicking View
Unfollow Alarm, select the alarm you want to follow again. Click OK, and the device will keep following the
corresponding alerts.
Table 5-1 Alerts and Suggested Action
The WAN port has no link.
Please check whether a cable is plugged into the
WAN port.
The port is operating at 10Mbps.
Please check the peer port settings, unplug and re-
plug the cable, or replace the cable.
There is more than one DHCP server in the LAN
network.
Please disable the extra DHCP server in the LAN
network.
There is more than one DHCP server in the WAN
network.
Please disable the extra DHCP server in the WAN
network.
Address pool of DHCP server is full.
Enlarge the DHCP address pool.
WAN & LAN Address Conflict.
Please check the IP addresses of WAN and LAN
ports. If the network addresses conflict (including IP
address conflict), change the IP of LAN port.
The WAN IP address is already in use.
Please check the WAN IP address. If it is a static IP
address, please change the IP address.
The LAN IP address is already in use.
Please check the LAN IP address. If it is a static IP
address, please change the IP address.
The IP address of the downlink address is already in
Please check the IP address of the downlink device.
If it is a static IP address, please change the IP
To Next Page
Loading...
