Web-based Configuration Guide Networks Settings
70
DNS Server: Enter the address of the DNS server pushed to the client.
MPPE: Use MPPE to encrypt PPTP tunnels. By default, encryption is not enabled on the server. Once MPPE is
enabled, the Internet speed will slow down. You are advised to disable MPPE if you don't have specific security
requirements.
PPP Hello Interval: Enter the interval for sending hello packets. You are advised to set the value to 10.
Click Save and the device will receive and process the VPN request.
2. Add the PPTP user.
Click +Add to enter a username and a password for authentication when the client dials in.
Select the network mode. PC to Router indicates the dial-in mode from PC to router. Router to Router indicates
the dial-in mode from router to router.
Enable Status and click OK.
To Next Page
Loading...
