Web-based Configuration Guide Fast Internet Access
1
2 Fast Internet Access
2.1 Connecting the Device
1. Wireless Connection
Connecting the Device to a Primary Router (WPS)
(1) Connect the mesh repeater to power source, and wait 1-2 minutes until the status of blue indicator changes
from blinking to solid on. The mesh repeater is started.
(2) Press the WPS button on the primary router.
(3) Press the WPS button of the mesh repeater within 2 minutes. When the system status LED is solid blue and
the three-bar signal status LED lights up in turn, the device connects to the primary router successfully. In
this situation, the default Wi-Fi disappears, and the Wi-Fi name and password are synchronized with the
primary router. Clients can connect to the amplified Wi-Fi of the primary router to access the Internet.
(4) If system status LED is solid red and the signal status LED is solid white, the network connection fails. Check
whether the primary router can access the Internet. If the system status LED is solid red and the signal
indicator is off, the connection to the primary router fails. Move the mesh repeater to a position closer to the
primary router, remove obstacles, and repeat the preceding operations.
Connect the Device to the Modem or the Other Router
Before performing this step, you need to connect to the Internet. Search for the wireless network with the Wi-Fi
name @Reyee-sXXXX by using a mobile phone or laptop. The mobile phone and laptop can log in to the web
management page through a browser.
Note
XXXX in the Wi-Fi name is the last four digits of the MAC address of each device. You can find the default
wireless network name and web login address at the bottom of the device.
To Next Page
Loading...
Need help?
General