Web-based Configuration Guide Fast Internet Access
3
If you forget the IP address or password, press the reset button for over 5 seconds to restore the default settings.
After that, log in again with the default IP address and password.
Caution
Restoring the factory settings will clear the current configuration and require a re-login. Please exercise
caution when performing this operation.
2.3 Network Settings (As a Mesh Repeater)
2.3.1 Getting Started
Ensure that the primary router can connect to the Internet successfully.
To use the device as a mesh repeater, remove the network cable from the device first.
2.3.2 Configuration Steps
Extend the Wi-Fi of WPS-supported router
Press the WPS button of the primary router and then the WPS button of the mesh repeater for networking.
For details, see 2.1 Connecting the Device.
Extend the Wi-Fi of other routers
Click Configure. The General Mode mode and WISP mode are available.
To Next Page
Loading...
Need help?
General