Web-based Configuration Guide
11
Figure 4-1 WAN Port Settings
4.4 Changing the MTU
Caution
This feature is supported by only the router mode and the WISP mode.
Sometimes, the ISP restrict the speed of large data packets or prevent large data packets from passing through.
As a result, the network speed is low or even the network is disconnected. In this case, you are required to set
the maximum transmission unit (MTU) to a smaller value.
Mobile Phone View: Choose More > Switch to PC view > More > Basics > WAN > Advanced Settings.
PC View: Choose More > Basics > WAN > Advanced Settings.
The default MTU value is 1500, which is the maximum MTU size. You are advised to gradually adjust the value
to 1492, 1400, or even smaller if necessary.
For details about the page, see Figure 4-1.
4.5 Configuring the Repeater Mode
4.5.1 Wired Repeater
Mobile Phone View: Choose More > Repeater Mode.
PC View: More > Basics > Repeater/WISP.