Chapter
3 Periodic Maintenance
c. Manually oiling
and
greasing each section
A WARNING
1.
Turn
OFF
the
power
before lubricating.
2.
Mount
the
cover
removed
in
place
after
lubrication.
Failure to
follow
these instructions
may
result in a serious injury.
All
of
the required lubrication points are marked with
red
paint. Use oil
or
grease depending on the function
of
the part.
Lubricate the press following the lubrication chart that is included with
the press.
[Recommended
lubrication
list
for
the
manual
lubrication]
«NOTICE»
1.
Use the recommended oil
and
grease. Do not use the used oil
or
oil with special additives.
2. The specific gravity
and
viscosity
of
the manual lubrication oil is higher than that
of
the oil for the centralized oiling
system
and
pump. When this oil is used for the centralized oiling system
and
pump, the oil circulation may be poor
and
then this
may
cause the trouble with the centralized oiling system
and
pump.
Maker
Oil
Grease
ALVANIAGREASEEP 1
Shell
GCOILSE100
ALVANIAGREASE 1
Mobil
Mobil DTE Oil Heavy MobiluxEP 1
ESSO
SPARTAN EP 100
LITHTAN 1
TERESSO 100
(Note) 1. The recommended oil is equivalent to anti wear type ISO (International Organization for Standardization)
VG
100.
2.
The
recommended grease is equivalent to the multipurpose grease
(Li)
NLGI No.
1.
3. Supply oil and grease at all the lubricating points every week for 3 months after installation. After that,
lubricate the press following the lubrication chart.
Maintenance Edition - 27
To Next Page
