Ryobi 3302H - Plate Mounting After Removal Process

Chapter 2 letE>SS~~itl'{;;§~ro.IB.t:tto!Pati~\Rl~t~~'.$tltil1§~(~ Plate Mounting and Removing, and Diagonal Image Adjustment Process
3. When Mounting a Plate after Removing
[Operation]
1. Push the plate remove but-
ton.
C@])
~
2. Push the plate remove but-
ton.
C@])
+ - •3. Push the plate remove but-
ton.
C@])
[Press process] [ Error J
(The drive lamp lights.) messa~e
occurrmg
position
The press starts to crawl. E-*6
~
The press stops at the tail
edge clamp opening po-
sition.
The press starts to crawl.
The plate tension is re-
leased.
The tail edge clamp
opens.
The leading edge clamp
opens.
The press stops at the
plate tail edge removing
E-*3
[Sound]
Starting
buzzer
sounds.
Warning
buzzer
sounds.
positio.!J.. __________________ -
[
Plate
J
mounted
indication
lamp
Lights
4. Open the safety cover "iuid- - - - - - - - - - - - - - - - - - - - - - - - - -
hold the plate tail edge.
-!- Buzzer for
_ _ the plate
removing
preparation
completed
sounds.
l
5. Push the plate remove but-
ton.
(~)
l
The press crawls in there-
verse direction.
The press stops at the E-*7
plate removing
positi~~ _________ _
6. Remove the plate:- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
!
7. Insert the next plate.
l
Operation Edition - 62
-r Buzzer for Goes off
-- the plate
mounting
preparation
completed
sounds.