Ryobi 3302H - Press Installing and Moving

Chapter 3 Precautions When Installing and Moving the Press
• Press installing and moving
Installing (wiring and piping) and moving of the press requires special knowledge and trained personnel to assure
the press performance and safety. So consult the dealer who you purchased the press from.
(The detailed information about the press installing and moving is given in the service manual. So the service
technician should follow the information given in the service manual.)
<Press installation>
To assure the safe operation, install each of the devices at the position shown in the illustration. Check the press
and devices position before the initial operation.
I Press with Damp~ning Solution Cooling/Circulation Device I
Dampening solution cooling/
circulation device
I Press with Semiautomatic Plate Changer I
Intermediate tank
0
RYOBI PCS-F
I
I
[
Air compressor
L]l
!Press, with Dampeoing Sqlutiori Circulation Device I
!Press with Semiautomatic,Piate Changer I
RYOBI PCS-F
I
I
Alr compressoD
[
I
'--
:::1
r-
tig
Dampening solution
circulation device
0
-
p
-
ti'D
Safety Operation Edition - 9