Chapter 1 Operation Procedures
!Press
with
pampeping
SolutiOd
Cdoling/Circi.Jiatiori
Device!
3. Water Section Preparation
1) Prepare the dampening solution cooling/circulation device.
(2)
(1)
Mix
the alcohol in the
dampening
solution
in
advance, and put it in the tank.
For the proper density
of
alcohol, please ask your
service technician when installing the press.
(Reference)
To
keep the proper dampening solution
level,
15
liters
of
dampening solution
should be prepared.
Remove the cap
of
the alcohol container and put
the alcohol in it.
(Note) When the alcohol is used up, bubbles will
appear in the tank easily. When the alcohol
is used up, immediately
set
the alcohol
density control dial (1) to "0" and supply the
alcohol in the alcohol container.
Set the power switch (1) at the ON position.
After running the device for from
15
minutes to 30
minutes and the dampening solution is properly
mixed and cooled, set the alcohol density control
dial (2) at the required density.
For the required density, please ask your service
technician when installing the press.
Put the hydrometer
(1) in the hydrometer column,
then check the alcohol density.
Operation Edition - 7
To Next Page
Loading...
