7) Cleaning the powder spray device
(2)
T1
(1) (2)
~
(3)
Chapter 3 Periodic Maintenance
After using the powder spray device, and then
not
using it for a long
time, the spray powder will harden in the spray hose. After using the
powder spray device, remove the powder bottle
(1}, set the spray volume
control lever (2) at the "0" position, and feed waste paper to use up any
spray powder remaining in the hose.
(Note)
1.
When
the spray powder in the bottle gets dirty
or
foreign
particles are mixed in, empty and dispose
of
the spray powder
in the bottle. Clean the inside
of
the bottle with a clean dry
soft rag.
2.
Do
not
use spray
powder
which
has
hardened
because
it
contains moisture.
When the spray powder blocks the spray nozzle, loosen the nut
(1
),
remove
the nozzle (2), and clean the nozzle (2) and nozzle tip (3).
(Note) When removing the nut (1), be careful not to drop the washers.
s)
~t~$~;,twitJ:t:It1~ros~nivsl§gflUi9:fii~§Qltrr·"·,
.
,.~ti.Rtii{tt~¥!9~
Cleaning the inside
of
the tank
of
the dampening solution cooling/circulation device
Foreign particles and spray powder will accumulate on the bottom
of
the
tank. Drain the dampening solution in the tank from the water level control
cup and clean the tank with a soft sponge.
9)
.~t~$~f.:~itlll~~.
(~
"
·l:~g;~sQJ~!l9:Blrm~t?lifi9k"tt««l~t!Ql1:ff1.~gi~~
Cleaning the tower
of
the dampening solution cooling/circulation device
Foreign particles will accumulate inside
of
the tower. Blow the air in to
clean the inside
of
the tower.
Maintenance Edition-
31
To Next Page
Loading...
