J. Data clear button
When pushing this button, the lamp will light. This
is used to clear the data on the floppy disk.
K. Color/conversion curve number set button
When pushing this button, the lamp will light. This
is used to input the color and conversion curve
number to each unit.
When inputting the data of the device for measuring
image area
of
plate (DEMIA), ink volume setter, or
ink
volume
setter-
CIP3, the conversion curve
number is used.
L.
Data
saving button
When pushing this button, the lamp will light. This
is used to save the data for each unit on the floppy
disk.
M.
Data
reading button
When pushing this button,
the
lamp will light. This
is
used
to
read the data
on
the
floppy disk.
N.
Number
input
button
This is used to input the
job
No. when saving the
data on the floppy disk.
Also this is used to input the color and conversion
curve number on each unit.
0.
Reset
button
This
is
used
to release the button operation (H
through M) on the ink fountain preset panel and the
button operation
of
the ink fountain key 0 point reset
button (E).
P. Message display
The next operation message is displayed.
Chapter
1
RYOBIPCS-F
Q. YES/NO button
When pushing the
~
button
according
to the
message on the message display (P)t:bou can go
to
the next process. When pushing the
~
button, you
can return
to
the preceding process.
Optional Accessories Edition - 7
To Next Page
