Chapter
2 Blanket Cleaning Device
2)
Set the cycle set
button
•
...
0
1 2
3
4
jPRINTI
cftf
~
0
~
• •
5
6
7 8
9
,
..
i
&
CY-3
•.•
Blanket cleaning cycle
This is the process that cleans the blanket by the blanket cleaning device cleaning roller. Set the cycle time to
be
able
to properly clean the blanket.
Indication Cycle type
Setting possible
Setting pitch
Factory setting
range
value
20-65
Every 5
20 rotations
CY-3
Blanket cleaning cycle
rotations
rotations
[Cycle setting procedures]
Optional Accessories Edition - 28
There are 2 cycle setting buttons (1) and (2).
When pushing either button, the cycle indication (3) in the middle changes
and at the same time, the cycle indication and setting value
will
be
indicated on the counter panel on the delivery section operation panel.
(Note) When pushing the button
(1), the cycle set number is increased
and when pushing the button (2), the cycle set number is reduced.
The numbers can be changed from "0" to "9".
The setting value is set
by
using the counter set button
on
the delivery
section operation panel.
(Note) After completing the setting
of
the set value, return the cycle set
button indication to "0".
To Next Page
Loading...
