Sakura Tissue-Tek TEC 6 - Instrument (Rear Side)

24
[8] Parafn drain tray
A tray for collecting the excess paraffin generated by embedding. Each
tray has a capacity of 500mL.
[9] Forceps holder
A forceps holder for keeping the various types of forceps warm which are
used for embedding.
One holder is provided on either side of the dispenser, to accept a total of
six forceps. The forceps holders can also accommodate tampers.
[10] Intake port
This port is used to take in air to raise the cooling efciency of the cold
spot.
[11] Cold spot
A cooling plate used to quickly cool parafn at the bottom of a base mold
during embedding, to help correctly position the tissue sample.
[12] Hot plate
A work surface on which embedding is performed.
[13] Hand rest
A resin part that prevents accidental contact with the hot plate during
embedding.
1.6.2 Instrument (Rear Side)
[1] Power inlet
Connect the power cord here.
[2] Foot pedal connector
Used to connect the foot pedal.
[3] Control cable connector
Used to connect to the Cryo Module.
[1] [2] [3]