7. Glossary of Terms
99
7.1 Glossary of Terms
Auto operation
An operation mode where the instrument starts up automatically to be
ready for the embedding work at the preset start time and comes to a
pause at the preset end time.
Base mold tray
A tray that accommodates base molds of various sizes used for
embedding process. It is set in a warming chamber and heated.
Base mold warming chamber
A warming chamber in which an embedding tray has been set. Base
molds can be stored directly.
CM
This represents the Cryo Module.
Cold spot
A cooling device on the Embedding Module side. It is a local cooling
plate used to quickly cool the bottom of the base mold during embedding
process, to help position the tissue.
Control panel display
Used for running/stopping the instrument and setting various parameters
and conditions. It also serves as a monitor that displays the operating
status of the instrument.
Cooling plate
A cooling device on the Cryo Module side. It is a cooling plate that cools/
solidies the embedded parafn block.
Dispenser
A dispenser that dispenses parafn used for embedding according to the
user’s operation. There is a mechanism to adjust the parafn ow rate.
Dispensing
To pour molten parafn into a base mold.
EM
This represents the Embedding Module.
End time
A time at which the instrument comes to a pause in the automatic
operation mode.
Finger plate
A switch for dispensing parafn used for embedding.
Pressing the switch starts dispensing, and releasing it stops dispensing.
Dispensing will stop after the switch is held for 1 minute.
To Next Page
Loading...
Need help?
General
