Sakura Tissue-Tek TEC 6 - Ending the Auto Operation before the End Time

70
3.2.6 Ending the Auto Operation before the End Time
During auto operation, you may want to put the instrument in the paused
mode because the day’s work is over although it is not yet the end time. In
this case, follow the steps below to end the operation:
1. Touch the “End” button [1] on the
Operation screen.
2. To end the operation, touch the "
"
button.
To cancel the operation, touch the
"
" button.
NOTE:
Once the instrument stops,
it will remain in the paused
mode until the next start time.
NOTE:
The sample screen on the
right shows the instrument in
the paused mode.
[1]