Salus SQ610 Quantum - Pairing with receiver RX10 RF

23
5.7 Pairing with receiver RX10RF
1
SALUS
SmartHome
Go to SALUS Smart Home app
3
Now thermostat is looking for the
signal from the coordinator...
5 64
Open main menu. Select „Settings”. Now enter to the „Setup Equipment”.
7 8
App has started scanning...
2
For easier installation, please make sure you have already added RX10RF receiver to your ZigBee network (please refer to the RX10RF receiver manual
instruction).
Please note:
Press „Scan for equipment” button
9
Thermostat is connected. Go to the
Smart Home app to congure it.
...Gateway has started ashing red and
searching for the thermostat...
Select “YES” by „ ” or „ ”
buttons. Conrm by button.