Sam4s ELLIX 20 - Serial Interface DIP Switch Settings

 - 13 -
1-7-1. Serial Interface Specification
 DIP Switch Set 1 Functions
SW FUNCTION ON OFF DEFAULT
1 Handshaking XON/XOFF DSR/DTR OFF
2 Word Length 7Bit 8Bit OFF
3 Parity Check Yes No OFF
4 Parity Selection EVEN ODD OFF
5 OFF
6 OFF
7
Baud rate selection Refer to the Following Table
OFF
8 Dip Switch Select Dip Switch 2 Dip Switch 1 -
 Baud rate selection
Transmission speed SW – 5 SW – 6 SW – 7 Remark
2400 baud
ON ON ON -
4800 baud ON ON OFF -
9600 baud ON OFF ON -
14400 baud ON OFF OFF -
19200 baud OFF ON ON -
38400 baud OFF ON OFF -
57600 baud OFF OFF ON -
115200 baud OFF OFF OFF Default
 Dip Switch Set 2 Functions
SW FUNCTION ON OFF DEFAULT
1 Mode Selection STAR EPSON OFF
2 *Kitchen Bell Enable Disable OFF
3 Auto Cutter Disable Enable OFF
4 Self Test Hexa Dump SelfTest Mode OFF
5 OFF
6
Select Print Density Refer to the Following Table
OFF
7 Data Receive Error Ignore Print “?” OFF
8 Dip Switch Select Dip Switch 2 Dip Switch 1 -
*Kitchen Bell is option.
 Print Density
Print Density SW - 5 SW – 6 Remark
1 ( Light ) ON ON -
2 OFF OFF Default
3 ON OFF -
4 ( Dark ) OFF ON -